Vantec Computer Drive MRK 103F User Manual

EZ•Swap Quick Installation Guide

Model MRK-103F

1. Front Panel Description

1. HDD Access indicator

2. Power indicator

3. Active-handle

4. Handle

5. Cartridge frame

6. Key lock

2. Function Settings and Operation

2-1 Power Indicator and HDD Access indicator

When power is turned on, the indicator will displays the following

Item

Power Indicator

HDD Access Indicator

Indicator

Green LED

Amber LED

2-2 Key lock

Status

Segment

Power status

Security status

OFF

Locked (Irremovable)

Unlocked (Removable)

3. Installing Hard Drive into Cartridge

Step 1

1-1. Pull the active-handle outwards and use the miniature key provided and insert into the key hole,

turning the key anti-clockwise, then the handle will auto-eject for pulling out. (Fig.1)

Fig. 1

Model MRK-103F

Step 5

5-1. Slide the carrier body back into the cartridge frame. (Fig.7)

Fig. 7

5-2. Push carrier body further into cartridge frame until fully inserted. (Fig. 8)

Fig. 8

Step 6

6-1. Install the module into a 5.25” half-height expansion bay. Insert the DC power cable and the IDE

cable of the user’s chassis to connectors located at the back plane of the cartridge frame. Then,

fully secure the module to the chassis by using the four M3x6 screws provided. (Fig.9)

Fig. 9

6-2. Pull the active-handle outwards and use the miniature key provided and insert into the key hole,

turning the key clockwise to secure the handle. (Refer to section 2-2 Key lock)